CTH02 (two-tip) Cutting Tip Holder

CTH02

The CTH02 (two-tip) Cutting Tip Holder allows easy use of carbide cutting tips without having to manipulate the Tooke® Paint Inspection Gage to make the incision and then manipulate the gauge again to view the incision through the microscope

If your coatings tend to be right on the cusp between using one tip or another, this two-tip holder lets you keep your two most-used tips at the ready. You can “bracket” your incision angles by mounting two different tips to create different incising geometries.

CTH02 Cutting Tip Holder

(Please note: Cutting tips holders do not come with tips.)

  • 1.6" (4.1cm) long overall
  • 0.47" (1.2cm) tall exclusive of feet and tip(s)
  • 0.98" (2.5cm) deep
Each tip slot in the CTH02 has two set screws at 90 degrees to
each other to securely hold the cutting tip in place.
CTH02 Cutting Tip Holder
Held (backwards) for scale and to show a mounted cutting tip.
Note that, for use, the chosen tip is drawn towards the user for smoothest incision.
CTH02 Cutting Tip Holder

The new CTH02 has a tip storage compartment that holds two cutting tips.
(Please note: Cutting tips holders do not come with tips.)CTH02 Cutting Tip Holder
CTH02 shown with 1X tip in compartment.
Carry case modified to carry CTH02.
<

CTH02 Cutting Tip Holder

Website design and management provided by SnowTao Editing Services.

Contact Information

Mailing and Shipping Address:

Micro-Metrics Company
4450 Ansley Lane
CUMMING, GA 30040-5252

Telephone Number:

(678) 947–3723

2019 new address:

Elenor2020 @
Micro-Metrics.com


(100% woman-owned business too.)